Spray Foam Insulation in High Park, ON
Insulation for the brick houses and semis north of the park, from the top-floor ceilings down to the rim joists.
We install spray foam insulation in High Park, along with attic, wall and basement insulation for the older brick homes north of the park. We're about 3 km away. This page is about the streets north of the park in M6P, including the south end of The Junction.
Two- and three-storey brick houses north of the park
High Park North runs between Bloor Street, Runnymede Road, Annette Street and the rail tracks. The oldest houses go back to the late 1800s and early 1900s. Most are Victorian, Edwardian or Tudor-style, and a lot of them are detached brick homes two or three storeys tall.
That height changes how we insulate. Warm air rises through a tall house and escapes at the top, through gaps in the ceiling, around the attic hatch, and around plumbing stacks and chimneys. So we start at the top floor and the roof and work our way down.
A third floor usually means sloped ceilings under the roof. There's no attic to walk into above a sloped ceiling. You get a shallow rafter bay between the ceiling and the roof deck, and that's it. Closed-cell spray foam works well in a bay like that: it gives more resistance per inch than a batt, and the same layer stops air moving through the bay. Our roof insulation page goes into sloped ceilings and roof decks in more detail.
Early 20th-century semis
There are a lot of semi-detached homes in High Park North from the early 20th century. With a semi, we look at two places first: the rim joists and the attic line along the shared wall.
The rim joist is the band of framing that sits on the foundation wall and closes off the ends of the floor joists. In an unfinished basement you can see it at the top of the wall. Outside air comes in at the sill plate and through the gaps around each joist end. Spraying foam into each joist bay seals those gaps and insulates them in one go. A batt stuffed into the bay can't seal anything. Our basement insulation page covers rim joist work properly.
Up top, the party wall separates your attic from your neighbour's. If it stops short of the roof deck or has open gaps, warm air from both houses mixes in the attic and slips around your insulation. We check that line along the party wall before we give you a quote. A gap in the wall itself is a fire-separation matter for a qualified contractor or the City, so we point it out, then build up the attic floor on your side.
Insulating without spoiling the woodwork
Plenty of High Park North homes still have their leaded and stained glass, wood trim, French doors and fireplaces. We'd rather keep insulation work out of those rooms. Opening a wall for batts means pulling trim and working right next to leaded glass. So most of our effort goes into the attic, the roof and the basement, where none of that gets touched.
If your exterior walls have framed cavities, we can dense-pack insulation through small holes and patch them afterwards. Trim, doors and windows all stay put. The wall insulation page explains which walls can be dense-packed and which can't.
Any spray foam inside a living space gets drywall over it, because the drywall is what protects the foam from fire. Foam on a rim joist or under a sloped ceiling gets covered once it cures. In High Park homes we use spray foam where it pays off most, in the shallow bays and the leaky joints in the framing. Our home page explains the difference between closed-cell and open-cell spray foam.
Close by: Runnymede, Brockton and Little Portugal
We work in the neighbourhoods around High Park North too. Runnymede, to the west, has its own page. Heading east toward Dufferin, there's Brockton and Little Portugal. Each page talks about the houses there and the insulation they tend to need. If you're on a boundary street like Runnymede Road, what's on either page applies to your house.
Local details for High Park
- Postal codes: M6P
- Distance: About 3 km away in a straight line
- Permit rules: toronto.ca
- Nearby: Runnymede, Brockton, Little Portugal
About High Park: High Park, ON on Wikipedia ยท High Park on Google Maps
FAQ
Insulation questions from High Park
Yes. Spray foam inside a living space should have drywall over it. The drywall protects the foam from fire, so bare foam in a room or a finished basement isn't a finished job. In a High Park North house, that means the foam on the rim joists and under the sloped top-floor ceilings.
Yes. If the walls have framed cavities, we dense-pack them through small holes and patch the holes. The attic, the roof and the rim joists we can reach without touching a finished wall at all. Some brick walls have no cavity behind the interior finish, and those can't be dense-packed, so the work goes into the attic and the rim joists instead. We look at your walls before we quote.
No, not where there's heated living space on both sides. The part that matters is where the party wall meets the attic and the roof. If the wall stops short of the roof deck or has gaps, air moves between the two attics and around your insulation. That gap is a fire-separation matter for a qualified contractor or the City, and getting it looked at does more good than insulating the wall itself.
Services
Services in High Park, ON

Attic Insulation
Learn more
Loose-Fill (Blown-In) Insulation
Learn more
Old Insulation Removal
Learn more
Basement Insulation
Learn more
Roof & Flat Roof Insulation
Learn more
Wall Insulation
Learn more
Closed-Cell Spray Foam
Learn more
Open-Cell Spray Foam
Learn more
Spray Foam Insulation Cost
Learn moreGet a Quote
Request an insulation visit in High Park
Tell us the address and which part of the house bothers you, whether that is a cold top floor, a drafty basement or a ceiling with no attic above it. Phone or use the form. We'll set up a time to look at the house, then give you a written quote.