Old insulation removal in Toronto means taking out insulation that is wet, flattened, rodent-damaged or in the way of air sealing and spray foam, then insulating the space again. Premier Insulation Toronto does this for homeowners whose attics, sloped ceilings and rim joists hold material that decades and raccoons have ruined. Vermiculite is the exception: our crew does not disturb it.

When old insulation should come out

Old insulation should come out when it can no longer slow heat, or when it covers gaps that need sealing. Insulation works by holding still air. Once fibreglass batts or loose cellulose get wet, packed down or torn apart, they hold far less of it, and new material laid on top inherits the problem underneath.

Take it out when any of these is true:

  • It is wet or water-stained. A stain points to a roof leak, an ice dam or a bathroom fan venting into the attic, and that source gets fixed first. Mould on insulation points to the same kind of leak, and mould remediation goes to a specialist firm.
  • It is flattened. Batts squashed by storage boxes, foot traffic or old roofing work have lost the loft that made them insulate.
  • Raccoons, squirrels or mice have nested, tunnelled or left droppings in it.
  • It is crumbling, dusty or falling apart with age.
  • It sits over openings that need air sealing, such as the gaps around a chimney, plumbing stacks, wiring holes and the top plates of interior walls.

When a top-up over old insulation is fine

A top-up is fine when the old layer is dry, clean, still fluffy and sits on an attic floor that has already been sealed. In that case insulation removal is extra work that gains little, and we will tell you so.

Removing insulation before spray foam

Spray foam has to go onto clean, dry wood or masonry, so old insulation in the way comes out first. Foam bonds to whatever surface it touches. Sprayed over fibreglass, dust or damp paper facing, it grips that loose layer instead of the framing and can pull away later, leaving gaps that leak air.

Removing insulation before spray foam means pulling old batts out of the rafter bays of a sloped ceiling and out of the rim joist bays in the basement, then cleaning the surface. With the cavities bare we can see the framing, check it for water staining and apply spray foam insulation straight onto the wood. Closed-cell foam on a rim joist acts as the air seal and the insulation in one layer, which only works when it touches the joist itself.

How a removal job runs

Attic insulation removal is done with a large vacuum hose that runs from the attic down through the house to a removal vacuum outside, which empties the material into large bags. Nothing gets carried loose through your rooms.

Protecting the path through the house

Before the hose goes up, we cover the floors and furniture along the route from the front door to the attic hatch. When the hatch sits in a bedroom closet, the closet gets covered as well, along with the stairs leading to it.

Vacuuming the attic

One of our crew works in the attic, feeding the vacuum hose across the joists and into the eaves. Batts too big for the hose are rolled up by hand and bagged in the attic before they come down. The full bags stay outside until they are hauled away.

Checking the bare attic floor

With the insulation gone, we look over the bare attic floor: the ceiling plaster or drywall, the top plates, the wiring and the openings around the chimney and plumbing stacks. This is the one time all of it is in plain view. Leaks, rot or damaged wiring get pointed out to you before anything new goes in.

Vermiculite: where our crew stops

Vermiculite looks like small, light pebbles, grey-brown or gold, sometimes with a slight shine, poured loose between the attic joists or down into wall cavities. It does not come in batts or rolls, which makes it easy to tell apart from fibreglass.

Health Canada says some vermiculite insulation may contain asbestos and can be a health risk if it is disturbed during maintenance, renovation or demolition. It also found no evidence of a health risk while vermiculite stays sealed or isolated in an attic, and advises not disturbing it. Health Canada advises treating vermiculite insulation made before 1990 as if it may contain some asbestos.

When our crew finds vermiculite, the work stops. We leave it where it is and recommend you have a qualified lab or an abatement firm test it before anything else is done in that space. If it has to come out, removal is work for a licensed abatement firm, not for us.

If you find vermiculite in your attic:

  • Leave it alone. Do not vacuum it, sweep it or slide boxes across it.
  • Stop using the attic for storage and keep the hatch closed.
  • Have a qualified lab or abatement firm test it before any renovation, wiring or insulation work above the ceiling.
  • Tell any electrician, roofer or other trade who needs to go up there that it is present.

Animals in the attic

If raccoons, squirrels or mice have been in the insulation, a pest-control company deals with the animals and with how they got in before we start. Taking out insulation while animals still live up there only hands them a clean space to move back into.

After pest control has finished, we remove the damaged insulation along with the nesting material and droppings mixed into it, and bag everything for disposal. The bare attic floor then gets air sealed and insulated again, so the new material starts on a clean surface.

When the old insulation is failed foam

Old spray foam sometimes has to come out as well. Foam that cracked, shrank away from the studs or was sprayed over a roof leak hides the framing behind it, and the cause cannot be fixed until the foam is gone.

Spray Foam Removal

Spray foam removal is for foam that failed, pulled away from the framing or covers a problem such as a leak or rot. Our crew cuts and scrapes it off the wood or masonry, bags it and leaves the surface ready for repairs and new insulation.

After removal: seal, then insulate

Once the old material is out, the bare attic floor or wall cavity gets air sealing first and insulation second. Air sealing closes the openings that let warm, moist house air rise into the attic: the gaps around the chimney, plumbing stacks, light fixtures and wiring holes, plus the top plates of interior walls. Those spots are far easier to seal when nothing covers them, and that is a large part of what makes removal worth doing.

New insulation goes in next. Open attic floors are filled with loose-fill insulation, blown to an even depth across the joists and into the corners that batts never reach. Sloped ceilings, knee walls and rim joists get spray foam, because blown material will not stay put on a slope or a vertical face. Our attic insulation page explains how we build up the depth while keeping the soffit vents clear with baffles.

FAQ

Common questions about old insulation removal

Yes, when the old insulation is wet, flattened, rodent-damaged or covering gaps that need air sealing. Taking it out lets us seal the attic floor and lay the new insulation on a clean surface. When the old layer is dry, clean and still lofted, leaving it in place and adding more on top makes more sense.

Yes, as long as the old insulation is dry, clean and not hiding air leaks. New loose-fill can be blown over sound batts or cellulose to bring the attic up to the depth it needs. It should never go over wet, mouldy or animal-damaged material, or over vermiculite, which stays undisturbed until it has been tested.

Vermiculite looks like small, light pebbles in grey-brown or gold, sometimes with a slight shine. It was poured loose, so it fills the spaces between joists like coarse gravel rather than lying in batts. If you spot it, leave it alone and have it tested before any work is done.

No, our crew does not remove or disturb vermiculite. Health Canada advises treating vermiculite made before 1990 as if it may contain some asbestos, and taking it out is work for a licensed abatement firm. Once a lab has tested it and any removal is complete, we can air seal and insulate the attic.

Yes, a pest-control company should remove the animals and deal with how they got in before we start. Pulling out insulation while raccoons, squirrels or mice are still there gives them fresh space to return to. After pest control is done, we remove the damaged insulation and insulate again.

Get a Quote

Get a spray foam insulation quote in Toronto

Tell us the address and which part of the house bothers you, whether that is a cold top floor, a drafty basement or a ceiling with no attic above it. Phone or use the form. We'll set up a time to look at the house, then give you a written quote.

Call Text Quote